What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 11:20

Can the fuse protect the electronic devices from lightning instead of a surge protector.
It also is a device that limits the change in current flow.
A circuit breaker is similar, but is resettable.
Devil’s Third director says panned Wii U game was innovative for its time - Nintendo Everything
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What happens when you have paranoid schizophrenia?
A fuse is a non-resetable over current circuit protector.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
When was the last time you had sex with someone much older than yourself?
eight
This device then solves the entire problem.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Important scientific finding confirms ancient biblical events - The Brighter Side of News
but I think this circuit , shows a few more pieces.
But… the neutral is now “floating” because of the 1 ohm resistance.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
nine
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
These devices are installed between the “hot” and “neutral” and protective ground.
Here's Why Rational People Skip Vaccines Even When They Trust Science - ScienceAlert
The third is lightning and “how it gets conducted into a home.”
Edit 2024–10.
He then describes the function of a fuse.
Forget Commander, Clive is the core of my new MTG Final Fantasy standard deck - wargamer.com
At least they know the answer if they wanted it.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
What are some innovative business ideas for leveraging AI in 2024?
What is lightning?
2024–10–16 [ OO OLAOYE OYEBODE ]
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
so, what happens?
What life lesson did you learn the hard way?
In schematic diagrams this is the symbol for a fuse:
The other is “what does a “fuse” do?”
Here is a simplified AC power diagram.
What are some difficulties in a JEE aspirant's life?
One is “what exactly is in a ‘surge protector’ ? ”
2024–10–10[John johnson John Johnson ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
He then asserts :
But it can get overloaded, and no longer works.
but this device (an Inductor) … impedes the rapid changes in the current.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Barnstars:
For this case there are devices called Metal oxide varistors (MOV).
He then describes Rainy Season and Lightning.
There are two important concepts here.
An AC voltage/ current source, and an ac inductive load.
the problem then depends on "how fast does the fuse operate?".
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At one ohm, the resistor has a maximum of 1 watt power.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
a photo is worth a thousand words.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
First Sentence:
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This one hit behind the barn.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This is where the MOV conducts again, and dissipated the energy.
(Dc diagram shown, AC is similar).
There are three different concepts here that are getting confused.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Because the load is inductive, the current lags the voltage.(by a bit).
These are simplified answers to the original question, and does not change anything I wrote above.
What does a fuse do?
[old diagram got deleted by accident]
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is 'the assistant's answer'
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Upvotes:
Now when you have a certain ac resistance, then a current flows in a loop.
what exactly is a ‘surge’ protector?
The bolt then partially travels down the line to your home.
So, the voltage could go up to 500 volts, and the fuse will not open up.
It seems Mohan does not understand the difference between a comment and an Answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
I post the exact comment here.